Alpha Microsystems AM-6060 Service Manual download pdf (Page 19)

Page 16 AM-6060 Service Manual

Rev. A00

1. Remove the two Phillips-head screws attaching the panel to the chassis.

Notice how the panel is positioned over the two alignment tabs on the bottom of the chassis.

When you reinstall the panel, you must make sure it is properly positioned over both tabs; if not,

you won’t be able to reinstall the two screws.

2. Tilt the top of the panel away from the chassis and remove it.

3. With the side panel out of the way, you can access both sides of the peripheral mounting bracket

and have complete access to all six drive bays.

4. To install a peripheral, simply slide it into one of the available bays and install the four screws

(two on each side) that hold the device in place.

5. Don't forget to attach the appropriate power and interface cables to your new peripheral.

6. After you have completed your peripheral installation, you can reinstall the side metal panel.

The metal panel is an integral part of the chassis assembly. With it removed, the chassis may

shift slightly, either forward or backward. To reinstall the panel, you can realign the chassis by

placing one hand on the top of the chassis and applying pressure either forward or backward.

With the chassis properly aligned, the panel will slide into place.

ADDITIONAL DOCUMENTATION

Each peripheral device sold by Alpha Micro is covered by its own set of installation instructions. The

installation instructions include information on jumper settings, termination, and cabling. Before

installing a peripheral, make sure you read the documentation pertaining to the device.

If the documentation was not included with your peripheral device, it is probably contained on the

AlphaCD which is distributed to all Alpha Micro Value Added Resellers on a quarterly basis, and on our

Web site at

www.amos-online.com

1 2 ... 14 15 16 17 18 19

No comments

Alpha Microsystems AM-6060 Service Manual Page 19