Alpha Microsystems Eagle 100 Specifications download pdf (Page 24)

Page 2-6 Eagle 100 Hardware Installation

2.2.3Mounting the Roadrunner Board

To install the Roadrunner board in the Eagle chassis, special mounting hardware is

required. The mounting hardware consists of a metal corner bracket and flat mounting

plate. These two additional items are included with your Eagle installation kit.

The illustration below shows the additional mounting hardware and their corresponding

Alpha Micro part numbers:

Corner Bracket

DWF-20753-07

Mounting Plate

DWF-20754-01

MC1254

Eagle Chassis Mounting Hardware

The inside area of the mounting plate contains two separate sets of metal standoffs.

One set of standoffs is slightly higher than the other. The higher set of standoffs are

located near the outside edges of the mounting plate and are not used with this

installation. The AM-174 board will mount on the lower set of standoffs and must be

properly oriented to avoid any shorts to the circuitry on the solder side of the board. The

following illustration indicates the correct locations of the AM-174 mounting standoffs.

NOTE: The following illustrations showing the inside view of the mounting plate are

purposely displayed upside-down to show the actual position required when connecting

the AM-174 to the Eagle system.

PDI-00172-60, Rev. A02

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 88 89

No comments

Alpha Microsystems Eagle 100 Specifications Page 24